Search found 18 matches

by sake007ro
Fri Jun 19, 2009 5:53 pm
Forum: General Tech
Topic: Piazza resurection
Replies: 3
Views: 4562

Sorry,i still don't know how to upload a picture and see it in the post :(
I have uploded many,but they are in photobucket.
by sake007ro
Thu Jun 18, 2009 10:12 pm
Forum: General Tech
Topic: Piazza resurection
Replies: 3
Views: 4562

Piazza resurection

Hello again my friends! I have started to rebuild the engine of my Isuzu Piazza 87.The car is a non-turbo and has auto transmission. The engine was first of all dirty,full of mud and oil. I had water and oil leaks all over the place and it ran very bad. I have bought and assembled new gasket set,new...
by sake007ro
Sat Apr 12, 2008 5:27 pm
Forum: Drivetrain - Motors, Turbos etc..
Topic: turbo and non turbo ecu`s
Replies: 7
Views: 6698

Damn it!I only have the turbo`s flywheel....i thought it will work...it is good that u told me that cause i would have bought a turbo clutch...knowing this,it would be good if you could send me a flywheel and i would pay you,if i don`t find one here and is not verry expensive.The problem is i live i...
by sake007ro
Sat Apr 12, 2008 9:14 am
Forum: Drivetrain - Motors, Turbos etc..
Topic: turbo and non turbo ecu`s
Replies: 7
Views: 6698

ecus

Thanks a lot for the infos! I thought so!As it is hard to find anything,i was afraid that i nedeed another ecu...it is good to know that won`t be necessary. I know what pin connector you are talking about.I also have the tools for making the bigger hole for the manual.I am just verry anxios to do th...
by sake007ro
Sat Apr 12, 2008 2:58 am
Forum: Drivetrain - Motors, Turbos etc..
Topic: turbo and non turbo ecu`s
Replies: 7
Views: 6698

ecus

...the ecu type is ITEC not JECS...i know that u fellows have the JECS ones.
by sake007ro
Sat Apr 12, 2008 2:55 am
Forum: Drivetrain - Motors, Turbos etc..
Topic: turbo and non turbo ecu`s
Replies: 7
Views: 6698

ecus

I forgot! i only have two ecus:the one from the auto and the one from the turbo.When mounted,the turbo ecu makes my car drive like heaven...it eats the asphalt...but only for 5 minutes until the amount of gas is too much and chokes the engine. The question was:can i use the auto`s ecu with the manua...
by sake007ro
Sat Apr 12, 2008 2:49 am
Forum: Drivetrain - Motors, Turbos etc..
Topic: turbo and non turbo ecu`s
Replies: 7
Views: 6698

turbo and non turbo ecu`s

I have 2 piazza`s.One non turbo wich is registered and one turbo not registered and wich hasn`t much on it. The non turbo has an auto transmission with 4 speeds and the turbo has a manual trans with 5 speeds.Unfortunatly the turbo`s engine is nude,that means i have only the block,the exhaust manifol...
by sake007ro
Wed Apr 09, 2008 3:46 am
Forum: General Tech
Topic: Isuzu engines
Replies: 10
Views: 11718

Isuzu engines

Hi there!
I started to search some parts for my piazza and i bumped into engine codes like G200Z,G200W,G200 and others.
My car has the g200 simple without any Z or W.
Does anybody now what difference is between those engines?
Thanks.
by sake007ro
Sat Nov 17, 2007 10:04 pm
Forum: General Tech
Topic: My Isuzu Piazza 1987
Replies: 18
Views: 25285

I will read the procedures and try to do the checks.
Thanks!Keep touch.
by sake007ro
Fri Nov 16, 2007 9:24 pm
Forum: General Tech
Topic: My Isuzu Piazza 1987
Replies: 18
Views: 25285

Could it be the injectors that may be obstructed from spreading gas when cold and after it dilatates runs better???
by sake007ro
Fri Nov 16, 2007 7:54 pm
Forum: General Tech
Topic: My Isuzu Piazza 1987
Replies: 18
Views: 25285

I'm sure this isn't mechanical, where are you adjusting the idel, not on the quadrant where the cable attaches I hope. First do the standard check on the TPS using the manual to check resistance readings for off, mid range and full throttle. Warm up the engine and make sure ignition timing is corre...
by sake007ro
Thu Nov 15, 2007 1:33 am
Forum: General Tech
Topic: My Isuzu Piazza 1987
Replies: 18
Views: 25285

Isuzu designed relays into the oil pressure and alternator output. if either of these are below the minimum it will kill the engine. Does the engine continue running if you hold the gas pedal steady and die after you let go of it??? Jim Hi there madcat! I guess we meet again,this time on different ...
by sake007ro
Thu Nov 08, 2007 5:40 am
Forum: General Tech
Topic: My Isuzu Piazza 1987
Replies: 18
Views: 25285

Thanks for your advice! At the moment i don`t have the time to work on the car,i guess i will during the weekend.I have to because i worked on it last weekend and now i can`t start it.It starts but then dies suddenly,over and over again. It did that before but just one time;at the second key it woul...
by sake007ro
Tue Nov 06, 2007 1:24 am
Forum: General Tech
Topic: My Isuzu Piazza 1987
Replies: 18
Views: 25285

Hi,thanks again for your help wedgenut. I read the email that u sent me.I will go on with the parts search,after i will figure what parts i really need,and i will write to 117coupe.He was verry kind and will help me! I will take a look at the ECU and give u it`s number. The thing is that i really wa...
by sake007ro
Sun Nov 04, 2007 2:14 am
Forum: General Tech
Topic: My Isuzu Piazza 1987
Replies: 18
Views: 25285

Ok,pfu,man it was a long day! I changed all the hoses i could(little ones i mean),i ripped off the grill that is behind the filter box-i read on isupage that thing really obstructs the air flow-i cleaned the two MAS elements with carb cleaner. SAME SHITTY RESULT. The idle flucuates big time when the...