5 speed 1' coarse spline 10 teeth output shaft

After a Piazza or just some parts. Here's the place to go.
Post Reply
blinky bill
Learner
Learner
Posts: 2
Joined: Tue Oct 20, 2015 11:36 am
Location: Melbourne

5 speed 1' coarse spline 10 teeth output shaft

Post by blinky bill » Tue Oct 20, 2015 11:57 am

Hi
I,m after a Gemini / Isuzu 5 speed 1' coarse spline 10 teeth output shaft / yoke
Melbourne area
Thanks Tony

IZU069
Power Moderator
Power Moderator
Posts: 963
Joined: Wed Sep 14, 2005 2:59 pm
Location: Melbourne (Orstralia)

Post by IZU069 » Wed Oct 21, 2015 8:09 am

Presumably also with the 1" circliped UJ? (As opposed to swaged 1" or larger Gemini etc types.)
IZU069 - ISUZU means a lot to me.

blinky bill
Learner
Learner
Posts: 2
Joined: Tue Oct 20, 2015 11:36 am
Location: Melbourne

Post by blinky bill » Fri Oct 23, 2015 2:55 pm

After any type as long as it's 10 teeth as I will be modifying it to suit a different prop shaft
Tony

IZU069
Power Moderator
Power Moderator
Posts: 963
Joined: Wed Sep 14, 2005 2:59 pm
Location: Melbourne (Orstralia)

Post by IZU069 » Sat Nov 21, 2015 8:24 am

Sorry for the delay. I found a 10x1" with 1" UJs. (All other UJs were fine spline.)

I was going to post a pic but don't think I can (no image storage on this site??).
There is some surface rust which these days I'd probably electroplate off but emery or steel wool should do fine.

I'd want $20 plus P&P.
IZU069 - ISUZU means a lot to me.

Post Reply