SuperPro poly:
is that the same bush to fit the lower arm/k-member of the Piazza?
Gemini front lower control arm bush same as JR?
- Impulsive Yank
- Member
- Posts: 70
- Joined: Mon Jan 23, 2006 7:36 am
- Location: USA
Gemini front lower control arm bush same as JR?
88 Impulse Turbo
will do good deeds for beer
will do good deeds for beer
Yeah these are Gemini ones but I had to machine down the shell so that it would fit. Just couldn't press it in otherwise. Only had to take off about 0.5mm I think. I suppose they figure the Gemini arm is going to have some give in the holes being thinner steel. Also Gemini arm holes would've been spread out once already from the original bushes installation so I suppose they're compensating for that too. The standard bushes on Gemini and JR arms appear to be the same.
Mine aren't Super Pro ones though so those could be fine.
Gemini arm with some JR bushes sitting next to it (stuffed the rubber on the small end getting them out of the arm)
Mine aren't Super Pro ones though so those could be fine.
Gemini arm with some JR bushes sitting next to it (stuffed the rubber on the small end getting them out of the arm)
- Impulsive Yank
- Member
- Posts: 70
- Joined: Mon Jan 23, 2006 7:36 am
- Location: USA