Gemini front lower control arm bush same as JR?
Posted: Tue Aug 22, 2006 5:58 pm
SuperPro poly:
is that the same bush to fit the lower arm/k-member of the Piazza?
is that the same bush to fit the lower arm/k-member of the Piazza?
Welcome to IsuzuPiazza.com :: Uniting Isuzu/ Holden Piazza Enthusiasts since 2002
Uniting Holden / Isuzu Piazza Enthusiasts
http://www.isuzupiazza.com/forum/
Gemini front lower control arm bush same as JR?
Page 1 of 1
Posted: Wed Aug 23, 2006 11:38 am
supposedly yeah and from my personel experience it looks to be the same
Posted: Wed Aug 23, 2006 11:43 pm
Yeah these are Gemini ones but I had to machine down the shell so that it would fit. Just couldn't press it in otherwise. Only had to take off about 0.5mm I think. I suppose they figure the Gemini arm is going to have some give in the holes being thinner steel. Also Gemini arm holes would've been spread out once already from the original bushes installation so I suppose they're compensating for that too. The standard bushes on Gemini and JR arms appear to be the same.
Mine aren't Super Pro ones though so those could be fine.
Gemini arm with some JR bushes sitting next to it (stuffed the rubber on the small end getting them out of the arm)
Mine aren't Super Pro ones though so those could be fine.
Gemini arm with some JR bushes sitting next to it (stuffed the rubber on the small end getting them out of the arm)
Posted: Thu Aug 24, 2006 5:06 am
great, thanks for the visuals.
what brand are those yellow ones?
what brand are those yellow ones?
Posted: Fri Aug 25, 2006 12:49 am
They're Selbys. Don't think they're around anymore just got them as old stock cheap off Ebay.