Welcome to IsuzuPiazza.com :: Uniting Isuzu/ Holden Piazza Enthusiasts since 2002

hey all

Im so close to having my car back up and running but i have removed the rooted old security system from the car as it was not operational. the people who did the job made a huge mess of whats what and now i need to know what wires go from the coil to earth and the tacho and which ones go from the ignigter pack to the + ive side of the coil. if anyone could post a picture of the coil and its connections it would be appreciated.

cheers

lucan

The lug with black wires attached goes to the - on the coil, white ones to +

yeah all those wires were cut and soldered to the security system wires. i have figured it out anyway as the car is now running but i cant get the tacho to read any revs. thanks anyway

cheers

lucan

The second wire attached to the lug on the coil goes off to a single pin connector this appears to be the tacho signal according to the wiring diagram.

If youve hooked the wrong side up to the tacho theres a good chance youve blown the kent out of it.

Bob.