Alloy BullBar for a Piazza.

Rodeobob · Post by **Rodeobob** » Wed Nov 30, 2005 12:09 am

If your gunna get a fuck off cooler and front mount it you need protection.

Its the bar off the jackaroo. The mounting brackets are the same width apart as the Piazzas rails.

Cheers. Bob.

madmike · Post by **madmike** » Wed Nov 30, 2005 6:36 pm

ohhh bob thats jst mean!!!!

Post by **wedgenut** » Thu Dec 01, 2005 5:44 pm

Jeez Bob you are a seriously twisted bloke and you should stop taking those tablets, anyway its a half assed job, cut the back out to make it a ute and fit a 3" chrome roll bar with spotlights and gunmounts. It would come in handy in some suburbs.

Rodeobob · Post by **Rodeobob** » Thu Dec 01, 2005 11:12 pm

You rekon. lol
How about this????

Im wrecking a 2 door Jackaroo here at the moment. Im pulling the body off the chassis and keeping the chassis to put a Piazza body on so its easier to get off the trailer up bush. Nah Nah not what your thinking im not wanting a 4x4 Piazza although it is a novel idea.
Plus the body is rusty.

I was looking at the 2 door Jackaroo body and thinking that it would make a good cab for a ute, well a 4x4 one. 2x4 would look wrong. Cut the cab off behind the doors and fill in the hole and build in some roll over protection into the new wall.
More leg room than a single cab Rodeo cabin, as well as a fair bit more cab height and an easy one to fit suspension seats in.

Just a thought.

Bob.