Posted: Sun Aug 20, 2006 7:21 pm
umm dunno listen to mine isit similar?
http://www.starlyon.com/bugle/piazza/piazza.avi
Yeah the pressure sender has a green wire coming off it? There's a green wire in that loom but it connects to the aircon clutch it seems. I just assumed they didn't bother including it in the XE loom because they all came with digital dash's that don't have an oil pressure gauge.
I got this pic of mine before I took it apart, the longer yellow wire goes off to the oil pressure switch, short one connects to the water temp sensor in the top side of the inlet manifold near the thermostat housing, green one connects to aircon compressor. Is the little white plug the one you were talking about before? Mine wasn't connected to anything and has that green tape wrapped around the wire to hold it like the plug for the extra auto idle air valve so I guess it's not supposed to be attached to anything.
http://www.starlyon.com/bugle/piazza/ot ... wiring.jpg
Only sensors on the lower part of the inlet manifold are all the temperature sensors above and below the thermostat housing section.
http://www.starlyon.com/bugle/piazza/piazza.avi
Yeah the pressure sender has a green wire coming off it? There's a green wire in that loom but it connects to the aircon clutch it seems. I just assumed they didn't bother including it in the XE loom because they all came with digital dash's that don't have an oil pressure gauge.
I got this pic of mine before I took it apart, the longer yellow wire goes off to the oil pressure switch, short one connects to the water temp sensor in the top side of the inlet manifold near the thermostat housing, green one connects to aircon compressor. Is the little white plug the one you were talking about before? Mine wasn't connected to anything and has that green tape wrapped around the wire to hold it like the plug for the extra auto idle air valve so I guess it's not supposed to be attached to anything.
http://www.starlyon.com/bugle/piazza/ot ... wiring.jpg
Only sensors on the lower part of the inlet manifold are all the temperature sensors above and below the thermostat housing section.