Free intake mod

Submit all your know how here. All workshop submissions must be reviewed and may be edited by a Moderator or Admin. Please speak to any of the forum staff first before submitting.
Post Reply
User avatar
Bugle
A total post whore
Posts: 953
Joined: Sun Jul 17, 2005 11:41 pm
Location: Sydney

Free intake mod

Post by Bugle »

Factory cold air setup has this plastic snorkel thing out the side of the engine bay pointing up opening out in a rectangular shape. It's almost against the top of the guard mounting which can't help air flow I guess. So it would probably be advantageous to rotate the plastic thing around.

To do that you have to:
1. Remove airbox & airflow meter assembly
2. Remove plate holding the snorkel
3. Rotate snorkle to point down/forward a bit
4. To reinstall plate put the snorkel through the hole then slide it down getting the plates holes to line up with the studs, you have to kind of force it out enough to get the plate over the bottom studs as the snorkle is trying to prevent you from pulling the plate out far enough to get over the studs.
5. Reinstall airbox/afm
6. Maybe make some ducting to go from the hole in the front bar to the intake

Image
Image
Image
User avatar
Rodeobob
Site Admin
Site Admin
Posts: 1243
Joined: Mon Jul 11, 2005 1:36 am
Location: Sunshine Nth Melbourne

Post by Rodeobob »

Geez thats some shiny underbonnet stuff youve got going on there, Im going to grab my sunnies and have another look.

Bob
Too many Piazzas to little money.

Currently unemployed. Watch this space.
Post Reply