Page 1 of 1
5 speed 1' coarse spline 10 teeth output shaft
Posted: Tue Oct 20, 2015 11:57 am
by blinky bill
Hi
I,m after a Gemini / Isuzu 5 speed 1' coarse spline 10 teeth output shaft / yoke
Melbourne area
Thanks Tony
Posted: Wed Oct 21, 2015 8:09 am
by IZU069
Presumably also with the 1" circliped UJ? (As opposed to swaged 1" or larger Gemini etc types.)
Posted: Fri Oct 23, 2015 2:55 pm
by blinky bill
After any type as long as it's 10 teeth as I will be modifying it to suit a different prop shaft
Tony
Posted: Sat Nov 21, 2015 8:24 am
by IZU069
Sorry for the delay. I found a 10x1" with 1" UJs. (All other UJs were fine spline.)
I was going to post a pic but don't think I can (no image storage on this site??).
There is some surface rust which these days I'd probably electroplate off but emery or steel wool should do fine.
I'd want $20 plus P&P.