Fuse-links needed also....!

Need parts for your impulse? Look here
Post Reply
User avatar
speedracerles
Senior Member
Senior Member
Posts: 157
Joined: Fri May 23, 2008 11:16 pm
Location: Port-Charlotte FL

Fuse-links needed also....!

Post by speedracerles »

Image

Just need the parts that conect to the battire!Image
Isuzu impulse turbo, my weapon of choice!
IZU069
Power Moderator
Power Moderator
Posts: 962
Joined: Wed Sep 14, 2005 2:59 pm
Location: Melbourne (Orstralia)

Post by IZU069 »

Unless you want to keep it original, I suggest upgrading to newer plastic flinks.

Though many types exist, on my Wasp I use the older female plug-in flink (20A to 100A though I recommend bolt-in types like the male plug-in flink for currents above 40 or 50A.

But the biggest Piazza flink is B (Black) = 1mm^2 = 26A capacity (so ordinary blade fuses will do - though I recommend beefing up the alternator to battery capacity etc.

I use a battery-post mounted 3-flink box from a Hyundai (as I recall) with all female plug-in flinks and the center flink can be disconnected from the battery.
Toyota uses the same but with the center flink a male bolt/plug-in type, and hard-metalled to the battery post.


I last worked on a suitable installation method (with (IMO) improved flink connectivity) compatible with the standard 1986 4ZC1-t Holden Piazza wiring back in 2008. (As I recall, one Piazza wire was rated UNDER its flink!).



As I recall, you had some funny arrangement. The 3-pin flink segment should be 3 flinks from the battery +12V whereas your red wire-flink loops the harness.
IZU069 - ISUZU means a lot to me.
Post Reply